How to Make Pocket Pussies?

In today's blog, we summarized 4 methods to make homemade pocket pussies. If realistic sex toys are beyond your budget and you prefer homemade sex toys made from accessible and cheap material, please dive into the step-by-step guide.

Method 1. Towel Pussy
You will need A towel with soft and smooth tactility, a latex glove, elastic bands. (Attention: do not use oil-based lubes on your latex glove)

• 1. Fold the towel into quarters;
• 2. Place the latex glove on the towel, with the cuff hanging off one side;
• 3. Roll the towel around the glove. If the towel is too loose, there is no friction and pleasurable stimulation and if the towel is too tight, it's tough to penetrate and would hurt your genitals;
• 4. Make sure it's optimum fit and then fix the towel with bands to prevent it unfurling;
• 5. Peel back the glove cuff so it covers the towel edge;
• 6. Place extra bands along the length of the towel to create tension;

Method 2. Cucumber Pussy
You will need A cucumber, a knife, a duct tape, several bands.

• 1. Cut one end from the cucumber;
• 2. Cut the cucumber in half lengthways;
• 3. Open the cucumber up and remove seeds from both sides. Once the seeds have been removed, take out small amounts of cucumber flesh until both sides fit snugly around the penis;
• 4. Once the preferred tightness is found, secure with rubber bands to keep the desired tension;
• 5. Wrap the cucumber with insulation tape or Duct tape. At this point, the user is able to accommodate any tightness preferences;
• 6. If preferred, a condom can be placed inside the cucumber. insert the condom before duct-taping the halves back together;
• 7. Stretch the condom rim over the cucumber edges and fold back;

Method 3. Mrs. Pringles
You’ll need: Large soda bottle or empty tube of Pringles, two household kitchen sponges, sellotape or duct tape, latex glove, sharp knife.

• 1. Remove the Pringles tube lid;
• 2. Sandwich a glove between two sponges;
• 3. Pull the glove cuff out, so that it hangs over the edge of the sponge;
• 4. Push the glove sandwich inside the Pringles tube;
• 5. Pull the glove cuff apart and slip it back over the rim of the container, so the edge is completely concealed;
• 6. Tape it securely;
• 7. If a Pringles tube has been used, cut a small hole in the base to prevent any suction stack;

Method 4: Silicone Pussy
You’ll need A candle bigger than a penis, sharp knife, silicone sealant.

• 1. Measure the penis width and length against the candle;
• 2. Draw markers into the candle approx 25% smaller than the measured penis;
• 3. Cut off two sides of the candle lengthways at the 25% mark;
• 4. Cut off the remaining two sides to create a solid rectangular shape;
• 5. Smooth the sides down and keep its girth at 25% smaller;
• 6. Cover the candle in silicone sealant, approximate half an inch thick;
• 7. Leave for several weeks until the silicone is totally dry;
• 8. Remove the candle and dispose of it, or if a successful size, keep it for further silicone pussies;
• 9. The remaining mold is the pocket pussy. It can take several attempts to get the correct sizing;